^ Surface Subsidence Control during Deep Backfill Coal Mining: A Case Study | Structurae
0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Surface Subsidence Control during Deep Backfill Coal Mining: A Case Study

Autor(en):




Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Advances in Civil Engineering, , v. 2020
Seite(n): 1-12
DOI: 10.1155/2020/6876453
Abstrakt:

Deep resource exploitation is imperative, but it is facing with more complicated mining environment and more dangerous mining disturbances to induce the potential catastrophe process. Solid backfill technology, which can control the strata movement and prevent potential hazards, has been used as the primary method in deep mining for surface subsidence control and ecosystem protection. In this study, taking backfill mining area no. 930 in the Tangkou coal mine as background, the probability integral model was adopted to predict the surface subsidence at different mining depths and filling ratios. The filling ratio was designed for deep mining based on the regression analysis of the predicted surface subsidence results. The study shows that the backfilling ratio at the Tangkou deep coal mining area should be controlled at a level greater than 82.5%, and the mining damage to the surface under this condition was analyzed. Furthermore, control strategies for deep backfill mining are proposed in which the backfill density can be enhanced by optimizing the tamping machine, material composition, and tamping process. Finally, the measurement of the backfill mass and surface subsidence showed that the actual filling ratio was controlled at 82.57%, which ensures adequate protection of the surface buildings during the mining process.

Copyright: © Baiyi Li et al.
Lizenz:

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
    Datenseite
  • Reference-ID
    10423040
  • Veröffentlicht am:
    02.06.2020
  • Geändert am:
    02.06.2021