Study on the Performance Evolution of Hydraulic Concrete under the Alternating Action of Freeze–Thaw and Abrasion

The hydraulic concrete in the alpine region is subjected to alternating actions of freeze–thaw (F) and abrasion (W) during operation, resulting in significant deterioration of concrete durability. In this paper, the water/binder ratio (W/B) was employed as the test variable, the working condition F group and W group were set as the control group, and the working condition F-W group was used as the test group. Fast-freezing and underwater methods are used for the alternating test. By measuring the mass loss, relative dynamic elastic modulus (RDEM), surface morphological characteristics, fractal dimension of concrete in each alternating cycle, and the evolution law of concrete performance under the alternating action of F and W was explored. The results show that compared with the control group, the alternating action will accelerate the mass loss of concrete, reduce the RDEM, and cause the deterioration of surface wear. The maximum increase in mass loss and RDEM of concrete is 1.92% and 20.11%, respectively. During this process, the fractal dimension of the concrete increases as the number of alternating cycles increases, but it still does not exceed the limit of 2.4. In addition, a relationship function between the fractal dimension and the mass loss rate, volume loss, was established. It was found that the experimental group had a good linear correlation, and the correlation was close to 95%, which was about 20% higher than that of the control group.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.