Shear Transfer in Concrete Joints with Non-Metallic Reinforcement

The use of non-metallic reinforcement can significantly reduce the carbon footprint of the construction sector. Mixed structures made out of steel and non-metallic reinforcement should be avoided due to the risk of galvanic corrosion. So far, researchers have been focusing on the load-bearing behavior in the longitudinal direction of the fibers. In this study, the behavior of the fibers in the non-metallic reinforcements is analyzed perpendicular to the fiber orientation. Therefore, a uniaxial shear test on a single bar (uniaxial shear test), as well as a series of push-off tests with reinforcements embedded in the concrete, was carried out. For both experiments, bars made of carbon fiber-reinforced polymers (CFRPs) and glass fiber-reinforced polymers (GFRPs) were investigated. In order to analyze the influence of non-metallic reinforcement in the joint, specimens without reinforcement have been tested as well. Also, the joint roughness and reinforcement ratio of the concrete joint was varied in the tests. The determined transverse shear strengths for the single bar exceed the values of the producer. For the push-off test, high standard deviations occurred, making it difficult to draw firm conclusions. Nevertheless, it is shown that increasing the amount of reinforcement leads to higher ultimate forces. The presented study emphasizes the necessity of further studies of the shear transfer in concrete joints.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.