Seismic Sequence Effects on Buried Pipelines Crossing Nonuniform Sites with Ground Settlement by Dynamic Centrifuge Test

The deformation and residual strength of the buried pipeline caused by the earthquake in nonuniform sites has an important influence on the safety of the pipeline. Most of the previous research focuses on the permanent ground deformation (PGD) caused by fault or transient ground deformation (TGD) due to seismic wave propagation independently. The mechanical character of buried pipelines crossing nonuniform sites during seismic sequence after ground settlement has not been studied. This article carried out a dynamic centrifuge experiment to simulate the seismic response of buried pipelines of polyvinyl chloride (PVC) and aluminum alloy (AL) horizontally crossing the loose and dense site and study the residual strength of pipelines after an earthquake. Two simulated seismic waves with 0.6 g and 0.3 g of input peak ground accelerations (PGAs) were inputted in sequence to simulate the strong and weak earthquakes. The deformations of ground and pipelines were obtained during and after seismic. The numerical model consistent with the experiment was established and compared with test, and it was found that the strain of pipeline caused by TGD was different between numerical and experimental results, especially in the loose site. The mechanical model of the pipeline by earthquake indicated that the total strain of the pipeline was composed of bending deformation by PGD and axial deformation by TGD. PGD caused by a strong earthquake had great effects on the deformation and residual strength of the pipeline. The strain of pipeline by TGD was compressive-extensional alternating mode between the loose and dense site and the strain amplitude reached peaks near the block interface in the loose site. The residual strain of pipeline in the dense site was a compressive strain, while in the loose site, it was compressive-extensional alternating mode and varied with the stiffness of the pipeline.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.