Seismic Design of Box-Type Unreinforced Masonry Buildings Through Direct Displacement-Based Approach

In the last decade, displacement-based seismic design procedures have been recognised to be effective alternatives to force-based design (FBD) methods. Indeed, displacement based design (DBD) may allow the structural engineer to get more realistic predictions of local and global deformations of the structure, and hence damage, under design earthquakes. This facilitates the achievement of performance objectives and loss mitigation in the lifetime of the structure. Nonetheless, DBD needs further investigation for some structural types such as masonry buildings.

In this paper, a direct displacement based design (DDBD) procedure for unreinforced masonry (URM) buildings is presented and critically compared to FBD. The procedure is proposed for box-type URM buildings with reinforced concrete slabs, bond beams and lintels above openings, which have shown acceptable seismic performance in severe earthquakes preventing out-of-plane failure modes. Seismic design of a three storey brick masonry building in a high seismicity region is discussed as a case study. The effects of ordinary and near-field design earthquakes, as well as load combinations and accidental eccentricity prescribed by current codes, were investigated. Finally, design solutions provided by FBD and DDBD were optimised and their construction costs were estimated. It was found that, particularly at small epicentral distances, neglecting the combination of horizontal seismic actions and accidental eccentricity may induce significant underestimation and an ideally more uniform distribution of strength demands on URM walls. In addition, construction costs resulting from DDBD may be significantly lower than those related to code based FBD procedures.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.