0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Seismic Damage Assessment of Reinforced Concrete Slab-Column Connections—Review of Test Data, Code Provisions and Analytical Models

Autor(en): ORCID
Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Buildings, , n. 2, v. 14
Seite(n): 465
DOI: 10.3390/buildings14020465
Abstrakt:

Reinforced concrete slab-column connections are vulnerable to punching shear failure when subjected to combined gravity and lateral loadings during earthquakes. Over the years, many experimental campaigns have been conducted and assessed the seismic performance of flat slabs. The experimental findings were used to derive empirical equations for the design provisions. The paper aims to provide a detailed description of the code development for seismic punching shear. Two current code provisions (ACI 318-19, EC 2 & EC 8-2004) for seismic punching shear are presented and discussed. Relevant and updated experimental data of interior slab-column connections without and with shear reinforcement are selected and assessed against the current design provisions with a focus on key response parameters such as the drift ratio and the gravity shear ratio. The ACI 318-19 limit drift line is considered to assess the lateral deformation demand for the connections with respect to the updated database. The gravity shear ratio is shown to have a considerable impact on the limit drift ratio of slab-column connections without shear reinforcement. The majority of the test specimens with no shear reinforcement experienced punching shear failure, followed by the specimens which showed a combined flexure–punching failure. Punching shear failures occurred for a range of gravity shear ratios of 0.2 to 0.9, while all combined flexure–punching shear failures occurred for gravity shear ratio values below 0.5. The shear-reinforced concrete slab-column connections can achieve much higher drift ratios. Most of the slabs were reinforced with shear studs, particularly in the range of gravity shear ratios of 0.4 to 0.6. Most test specimens failed by flexure for gravity shear ratio values of 0.1 to 0.7, followed by the specimens which failed in combined flexure–punching for gravity shear ratio values that ranged from 0.3 to 0.9. Finally, the available numerical and analytical models for seismic punching shear are presented with the objective of observing their potential strengths and limitations.

Copyright: © 2024 by the authors; licensee MDPI, Basel, Switzerland.
Lizenz:

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
    Datenseite
  • Reference-ID
    10760232
  • Veröffentlicht am:
    15.03.2024
  • Geändert am:
    25.04.2024
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine