Rotational Stiffness Investigation and Parametric Analysis of a Novel Assembled Joint in Lattice Shells

Although there are currently many types of lattice shell joints with different characteristics, assessing the flexural capacity of lattice shell joints is always a great challenge. In this paper, a fan-shaped assembled joint and a welded joint for comparison were subjected to bending tests to investigate the flexural behavior and rotational stiffness of the assembled joint. The strain distribution, load–displacement curve, moment–rotation curve, and damage modes of key parts were analyzed to determine the vulnerable parts of the joints. Our test results show that, with an initial rotational stiffness of about one third of that of the welded joint, the assembled joint specimen exhibits the obvious characteristics of a semi-rigid joint. The finite element analysis results were in good agreement with the experimental results. The results of our parametric analysis show that the rotational stiffness and ultimate moment of the assembled joint increase with increases in the spacing of the bolts and the number of bolts. The performance of the high-strength bolts had a significant influence on the flexural stiffness of the assembled joints. The spacing of the bolts and the number of bolts for the assembled joint are suggested to be greater than the height of the member section and more than three, respectively. The proposed theoretical formula can approximately simulate the initial rotational stiffness of the joint. More in-depth investigations are required in the future for assessing the mechanical behavior of FSA joints subjected to combined bending–compression loads.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.