A Review on Emerging Cementitious Materials, Reactivity Evaluation and Treatment Methods

Alternative to traditional concrete, sustainable concrete reduces cement content, waste management issues, and CO2 emissions. To achieve sustainable concrete, waste materials can be used as supplementary cementitious materials (SCMs) to partially replace cement. Fly ash, ground-granulated blast furnace slag, and silica fume have been heavily studied as SCMs. However, due to the retirement of coal-fired power plants and switching to renewable energy, existing SCMs are losing their dominance. With SCMs becoming more widely accepted as partial cement substitutes, there is fear that the current supply will not meet future demand. As a result, researchers have been looking for alternative SCMs. The circular economy can be achieved by reusing non-hazardous construction and demolition materials, timber, and metal/steel production waste as SCMs. This article discusses emerging SCMs, reactivity evaluation methods, their limitations, and treatment methods that may improve reactivity. Emerging SCMs can replace existing SCMs in quantity, but their supply to cement factories and low reactivity due to stable crystallinity hinders their use. Among treatment methods, particle size reduction effectively enhances reactivity; however, very fine SCM may increase the overall water demand due to the large surface area. Decades-old reactivity evaluation methods have relatively weak correlations and thus misreport the reactivity of SCMs. Newer R3 models, such as calorimetry and bound water, give the best correlations (R ≥ 0.85) for 28-day relative strength and better performance. Additionally, more concrete testing with emerging SCMs under different durability and environmental protection conditions is required and life cycle assessments are needed to determine their regional environmental impact.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.