Research on the Effect of Geometric Parameters on the Stress Concentration Factor of Multi-Planar KK-Joints and Carbon Fiber-Reinforced Polymer Wrapping Rehabilitation with Numerical Simulation

The focus of this paper is on estimating the stress concentration factor of circular hollow section KK-joints with different geometric parameters and subsequently assessing the effectiveness of carbon fiber-reinforced polymer (CFRP) wrapping for repairing joints with cracks. Different geometric parameters, such as θ (brace inclination angle), γ (the ratio of the outer diameter to the wall thickness of the chord), and τ (the thickness ratio of the brace to the chord), were studied to investigate changes in stress concentration using numerical simulation. The results indicated that the stress concentration factor was most sensitive to changes in θ, followed by γ. Subsequently, the effect of crack length and depth was analyzed to simulate cracks in joints subjected to reciprocating load. The results showed that changing D from T/16 to T/2 (where T is the thickness of the chord) can cause more stress concentration, with an average of 8.37%. Next, damaged joints were wrapped in carbon fiber-reinforced polymer as a repair. Analysis of the effects of different layers and directions of polymer wrap revealed that even six layers of wrapping effectively reduced the stress concentration compared to the initial model. Finally, based on the results of parametric analysis and nonlinear fitting, a calculation formula for the stress concentration factor suitable for KK-joints under axial loads is proposed.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.