Research on Formulating Energy Benchmarks for Various Types of Existing Residential Buildings from the Perspective of Typology: A Case Study of Chongqing, China

The full exploration of the energy-saving potential during the operation of buildings is an essential aspect of energy-efficiency retrofitting for existing residential buildings. Setting reasonable energy consumption quotas can promote the improvement of energy efficiency. The energy benchmark is one of the energy consumption quotas, which represents the general energy consumption level of similar buildings and serves as the energy-saving goal for high-energy-consuming buildings. This study aims to classify existing residential buildings based on their forms and actual energy consumption data and to set energy benchmarks for each building type. Taking typical existing residential buildings built before 2000 in Chongqing, a city in southwestern China, as an example, from the perspective of building typology, the study classified residential buildings into four types and determined the energy benchmarks. Then, energy-efficiency retrofitting measure evaluation and potential analysis were carried out for each type. The study shows that energy for cooling and heating accounts for a high proportion of energy use in existing residential buildings. The energy consumption of residential buildings is greatly affected by orientation and floor area. Point-like buildings with smaller areas facing west have higher energy benchmarks, while slab-like buildings with larger south-facing areas have lower energy benchmarks. The results and methods of the study can provide a basis for the formulation of energy benchmarks for residential buildings, as well as regional energy analysis, energy-saving potential prediction, and energy-saving measure evaluation.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.