Real-Time Monitoring of Concrete Vibration Depth Based on RFID Scales

The vibration of concrete is a typical concealed construction process, in which mature supervisory methods are lacking. The quality of vibration relies heavily on the subjective experience and sense of responsibility of the vibration operators. For the widely used hand-held concrete vibrators, existing methods for monitoring the quality of vibration primarily focus on the horizontal positioning of the vibrator. Due to the limited measurable range of vibration depth, these methods are inapplicable for monitoring the vibration depth during the vibration of deeper structures such as walls, columns, and large volumes of concrete. This paper makes the initial attempt to address the issue of monitoring concrete vibration depth, presenting a method that broadens the measurable range of depth in vibration monitoring. Inspired by the principles of optical and magnetic scales, this paper introduces a radio frequency identification (RFID) scales positioning system for the real-time monitoring of vibration depth. The proposed RFID scales vibration depth monitoring method theoretically has no upper limit on the measurable vibration depth, rendering it applicable to monitoring vibration depth of any extent. By comparing the positioning accuracy of different RFID scales hardware compositions, the optimal RFID scales hardware composition and the most effective RFID scales positioning algorithm were identified. The feasibility and accuracy of the vibration depth monitoring method based on RFID scales were validated through engineering field application. This method achieves centimeter-level accuracy in monitoring vibration depth, offers a tool for the precise control of vibration depth, and helps avoid potential quality issues in vibration.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.