Quantification of the Effect of Train Type on Concrete Sleeper Ballast Pressure Using a Support Condition Back-Calculator

Monitoring ballast support condition and improving current sub-structure and ballast maintenance strategies is critical to ensuring safe and efficient railroad operations. Researchers at the University of Illinois at Urbana-Champaign (Illinois) have developed a ballast support condition back-calculator, a non-destructive instrumentation method and corresponding analysis tool that quantifies ballast pressure distributions under concrete sleepers without interrupting revenue service train operations. This laboratory-validated non-intrusive method uses concrete sleeper bending moment profile and rail seat loads as inputs to back-calculate the reaction distribution using a Simulated Annealing optimization algorithm that incorporates Pareto Distribution as the random variable generator. In order to further understand in-service ballast support conditions, concrete surface strain gauges were installed on concrete sleepers at a revenue service field site to measure strains that could subsequently be converted into bending moments. This site is on a shared use rail corridor with traffic ranging from high speed passenger to heavy axle load (HAL) freight trains. Rail-mounted strain gauges were used to measure strains that were used to calculate the vertical wheel-rail loads to approximate rail seat loads. This paper quantifies the ballast pressure distributions beneath concrete sleepers under different types of rolling stock and evaluates how ballast support condition changes as a function of accumulated tonnage. A wide range of loads were observed at the field site, ranging from 4 to 35 kips (18–156 kN). Corresponding ballast pressures ranged from 14 to 175 psi (97–1,207 kPa), with sleeper-ballast contact area corresponding to 60% of the bottom of the sleeper area. The accumulation of 12.24 million gross tons (MGT) (12.44 million tons) did not generate a quantifiable change in ballast pressure values nor did it generate a change in the ballast support condition. The research results presented in this paper demonstrate the potential of the back-calculator to provide a stand-alone non-invasive method to quantify ballast support conditions, sleeper health, and sleeper bearing stress. Back calculator data will aid the rail industry in optimizing tamping cycles, enhancing safety, and developing more representative concrete sleeper flexural designs based on actual support conditions.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.