Point Load Test of Half-Cylinder Core Using the Numerical Model and Laboratory Tests: Size Suggestion and Correlation with Cylinder Core

The point load test (PLT) is intended as an index test for rock strength classification or estimations of other strength parameters because it is economical and simple to conduct in the laboratory and in field tests. In the literature, calculation procedures for cylinder cores, blocks, or irregular lumps can be found, but no study has researched such procedures for half-cylinder cores. This paper presents the numerical model and laboratory tests for half-cylinder and cylinder specimens. The results for half-cylinder and cylinder specimens are then presented, analysed, and discussed. A correlation of failure load between half-cylinder and cylinder specimens is established with a suitable size suggestion and correction factor. It is found that the failure load becomes stable when half-cylinder specimens have a length/diameter ratio higher than 0.9. In addition, the results show that the point load strength index (PLSI) of half-cylinder cores can be calculated using the calculation procedures for diametral testing on cylinder cores, and it is necessary to satisfy the conditions that the length/diameter ratio be higher than 0.9 and the failure load be multiplied by 0.8.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.