Optimal Quantity Investigation of Metakaolin and Silica Fume in Production of Durable Acid Resistance Alkali Activated Slag Concrete

The urgent requirement to reduce greenhouse gas emissions during Portland cement production and to enhance the durability of concrete in destructive environments are essential reasons to seek other alternative materials like alkaline activated binders. In this study, the feasibility of producing durable alkali-activated slag-based concrete under deteriorative environmental conditions was studied using 0, 10, 20, 30, and 40% of metakaolin (MK) and 0, 5, and 10% of silica fume (SF) instead of ground granulated blast furnace slag (GGBFS) and optimizing contents through the response surface method (RSM).To evaluate the performance of studied alkali-activated slag-based concrete in an aggressive environment, the permeability and the reduction in compressive strength of alkali-activated slag-based concrete under sulfuric acid attack have been investigated. In addition, the mass change of specimens after exposure was measured. The results indicate that replacing 40% of the slag with metakaolin and 10% with silica fume in alkali-activated concrete has reduced 9% and 34.9% of the compressive strength at 28 days, respectively. Also, increasing MK replacement up to 40% increased the water absorption to 27.8%, but 10% SF replacement reduced it to 17.7%. In addition, the alkali-activated slag-based concrete mass changes after 90 days of acid exposure were 2.3%, while the replacement of slag by 40% of MK and 10% of SF reduced this value to 1.14%. However, it improved the durability performance of alkali-activated concrete against sulfuric acid attacks.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.