Numerical Investigation on the Pulling Resistant Capacity of Steel Beam-Concrete Wall Joints with T-stub Connectors

The steel frame-reinforced concrete core tube structural system is widely used in mid-rise and high-rise buildings due to its good seismic behaviour and high construction efficiency. Since the steel frame and the reinforced concrete core tube are supposed to deform synergistically under earthquake action, the steel beam-concrete wall joint (SBCW joint for short) will be subjected to a significant pull-out force. Therefore, the pulling resistant capacity of the SBCW joint is quite important for the seismic performance of the overall structure. In response to the shortages of the existing SBCW joint types, a new SBCW joint with a T-stub connector was proposed and studied. The experimental and analytical research has indicated that there are different failure modes and force mechanisms of the SBCW joint under pull-out load, and further studies are required for the pulling resistant capacity. On the basis of recent research findings, a numerical investigation on the pulling resistant capacity of the joint is conducted in this study. An elaborate 3D finite element model of the SBCW joint is proposed, and the load performance, strain and stress development, deformation characteristics and failure modes are analysed in detail. Then, a series of parametric analyses are carried out based on the finite element model, indicating that the length and the web height of the T-stub connector, the number of shear studs on the connector and the reinforcement ratio of stirrups have an obvious effect on the pulling resistant capacity. Finally, the critical value of the embedded depth of the connector, which is found to be one of the most important parameters for the failure mode and pulling resistant capacity of the joint, is determined, and design recommendations are proposed for the SBCW joints with T-stub connectors.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.