Mechanical Properties and Leaching Characteristics of Geopolymer-Solidified/Stabilized Lead-Contaminated Soil

Ordinary Portland cement (OPC) is widely used in the solidification/stabilization of Pb-contaminated soils. However, many studies have suggested that the high content of Pb would degrade the mechanical properties of OPC-solidified/stabilized soils. This paper presents a new binder, geopolymer fine aggregate (GFA), composed of ground granulated blast furnace slag, fly ash, CaO, and Na₂SiO₃. For comparison, OPC was used as a conventional binder. Mechanical properties and leaching characteristics are typically used to evaluate the effects of binders on solidified/stabilized soils. Nevertheless, limited information on the mechanical properties and leaching characteristics of the GFA-solidified/stabilized soils is available. This study thus investigated the mechanical properties and leaching characteristics of geopolymer-solidified/stabilized Pb-contaminated soil. Unconfined compressive strength test, permeability test, synthetic precipitation leaching procedure, simplified bioaccessibility extraction, phytoavailability extraction (with diethylene-triamine penta-acetic acid), sequential extraction procedure, mercury intrusion porosimetry, and scanning electron microscopy (SEM) were performed on OPC- and GFA-solidified/stabilized soil. The results showed that the GFA presented a better effect on the mechanical properties and leachability of the solidified/stabilized soils than the OPC-solidified/stabilized soils. The GFA-solidified/stabilized soil displayed considerably lower leachability, bioaccessibility, and phytoavailability of Pb and higher mechanical properties and chemical stability than the OPC counterpart. This study demonstrated that GFA had a better effect than OPC on the solidification/stabilization of Pb-contaminated soils.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.