Laboratory Investigation of Fiber Bragg Grating Strain Sensors for Semirigid Base Asphalt Pavements

Aiming to evaluate the applicability of Fiber Bragg Grating (FBG) strain sensors for semirigid pavement monitoring, beam and cylinder specimens with three types of FBG strain sensors embedded in two kinds of classic semirigid pavement materials, asphalt mixture (AC-25) and cement-stabilized crushed stones (CSCS), were prepared in the laboratory. Four-point bending tests and uniaxial-compression tests were carried out under different loading frequencies and temperatures to evaluate the working properties of these sensors and then obtain the corresponding real sensitivity coefficients (SCs). The experimental results showed that the synchronism, repeatability, and linearity of all these sensors were prominent. However, the real SC results were significantly different from the recommended and dependent on many factors including temperature, the loading frequencies, the stress state, and the type of embedded material to different degrees. The SCs remained stable when the moduli of the embedded materials were high enough; otherwise, the SCs varied. Two SC prediction models that used the modulus of the embedded material as the only independent variable were developed to deal with the problem of instability. The modulus difference level between the sensors and the embedded material could integrate the factors roughly, except for the stress state. It is recommended that the factors above should be considered when using FBG strain sensors in practice, and it is still necessary to perform laboratory calibration in advance.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.