• DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke


An Investigation of Time-Dependent Deformation Characteristics of Soft Dredger Fill


Medium: Fachartikel
Sprache(n): en 
Veröffentlicht in: Advances in Civil Engineering, , v. 2020
Seite(n): 1-11
DOI: 10.1155/2020/8861260

The creep characteristics of soft clays have been studied for decades. However, the lateral deformation of soils is not allowed during the commonly used one-dimensional consolidation tests, which cannot describe the real deformation features of soils in practice. On the other hand, the influence of drainage distance on the mechanical properties of soil is still controversial, classified as hypothesisAand hypothesisB. For a better understanding of deformation characteristics of soft clay, especially which in long-terms, a series of conventional oedometer tests as well as novel geometric confined consolidation tests was conducted on soft dredger fill. The results show that the secondary consolidation coefficient of the soil sampleCαwould increase firstly, followed by a small decrease with the increase of consolidation pressure generally.Cαwould decrease with the consolidation time and also be reduced by preloading. The strain at the completion of primary consolidation would increase with the drainage distance, but theCαwould be affected little. Both compression indexCcandCαof soft clay would reduce after preconsolidation, in which two parameters show an approximate linear relationship. The creep coefficient of soft clay under the geometric confinementCkαεis larger than that under the oedometer testCαε. However, the trends of the relationship between the creep coefficient and loading are consistent regardless of the confinement conditions.

Copyright: © 2020 Wanying Wang et al.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
  • Reference-ID
  • Veröffentlicht am:
  • Geändert am: