0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Interfacial fracture behaviour between cement paste and epoxy coating - An experimental and phase-field approach

Autor(en):




Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: RILEM Technical Letters, , v. 5
Seite(n): 186-193
DOI: 10.21809/rilemtechlett.2020.133
Abstrakt:

Surface coatings are mainly applied to protect concrete structures against various environmental conditions. However, the interface between the concrete and coating is a weak link, and interfacial delamination is the primary mode of failure. Fracture resistance is the main design criteria for these materials, and therefore, it is necessary to investigate possible causes of interfacial failure for preventive measures. To this end, we have investigated the potential failure mechanisms and measured interfacial strength by performing a pull-off adhesion test on epoxy coated cement paste. From the pull-off adhesion test, adhesive (interface) failure between cement paste and epoxy is predominantly observed. It is observed that the adhesive (interfacial) strength for the sample tested on 50th day is more than the 28 days hydrated sample. This is due to additional curing of cement paste samples after coating epoxy which leads to higher interfacial strength. We also present the phase-field model (PFM) to predict the adhesive failure for this system. The results obtained from the PFM, i.e., load at failure and crack path are validated against experimental results. Finally, the influence of various material parameters such as elastic modulus and fracture energy of the interface on interfacial fracture behaviour is studied.

Copyright: © 2020 Pratik Gujar, Hirshikesh, Manu Santhanam, Ratna Kumar Annabattula, Pijush Ghosh
Lizenz:

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
    Datenseite
  • Reference-ID
    10579039
  • Veröffentlicht am:
    02.03.2021
  • Geändert am:
    02.06.2021
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine