In Situ Testing and Finite Element Analysis of a Discontinuous Mortise and Tenon Stone Bridge Under Natural Excitation

To study the dynamic response of multi-span mortise and tenon stone bridges under natural excitation, a bluestone multi-span stone bridge with a main span of 2.56 m in southern China was taken as the research object. Based on the collected pulsating signals of bridge piers and slabs, the natural frequencies and damping ratios of the main span bridge slab and pier were analyzed using the half-power broadband method (HPBM) and random decrement technique (RDT). Modal analysis was conducted using ANSYS, and the results were compared with those obtained from on-site experiments for further performance analysis. The research results of this article indicate that the natural frequency range of the 2.56-m bridge slab identified by measured signals is 48–49 Hz, and the damping ratio range is 33.33–36.61%. The natural frequency of the central pier is 75–76 Hz, and the damping ratio range is 26.39–27.83%. Through finite element modal analysis, the natural frequency of the bridge slab is 54.401 Hz, with an error of 10.5%. The natural frequency of the overall stone bridge is about 82.2 Hz, with an error of about 8.2%. The validated finite element model was subjected to normal water flow impact and erosion simulation. The results indicate that under erosion with fewer particles and lower flow rates, the upstream pier bottom at the center receives the highest relative erosion mass and displacement per unit area. The bridge deck near the main span also experienced relative displacement. Therefore, in the subsequent protection work, special attention should be paid to these components.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.