Fatigue Characteristics of Limestone under Triaxial Compression with Cyclic Loading

This paper presents an experimental investigation of the fatigue properties of limestone subjected to triaxial compression with axial cyclic loading. Tests were conducted on intact limestone samples with a loading frequency of 0.5 Hz and a confining pressure of 10 MPa. The test results show the following five points. (1) Under triaxial conditions, the axial and circumferential deformations at the failure point induced by cyclic loading are slightly larger than the corresponding deformations at the peak stress achieved by conventional compression tests. (2) The first level cyclic loading process has a strong influence on rock deformation in the primary phase during subsequent level cyclic loading. A smaller difference in stress amplitude between the two loading stress levels leads to less deformation during the latter. (3) Circumferential and volumetric changes are more sensitive to fatigue failure in terms of deformation and strain rate than axial changes. (4) The three phases of dissipated energy evolution are consistent with a sample's deformation such that the energy dissipation characteristics reflect the fatigue damage evolution process. (5) A new damage formula is proposed that can concisely describe a rock's zero-cycle damage and damage evolution.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.