0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Experimental Testing and Numerical Modeling of Robust Unreinforced and Reinforced Clay Masonry Infill Walls, With and Without Openings

Autor(en):



Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Frontiers in Built Environment, , v. 6
DOI: 10.3389/fbuil.2020.591985
Abstrakt:

This paper presents an overview of the experimental results obtained by combined in-plane/out-of-plane (IP/OOP) tests carried out on robust clay masonry infill walls. The combined tests were carried out on eight full-scale one-bay, one-story infilled reinforced concrete (RC) frames, plus one reference RC bare frame. In four cases, the masonry walls fully fill the RC frame: two walls are made of unreinforced masonry (URM), whereas the other two are made of reinforced masonry (RM), with both vertical and horizontal reinforcement. Each pair of specimens was tested up to different levels of IP drift before carrying out the OOP tests. Four other specimens, still made of URM and RM walls, are characterized by the presence of a central opening, and in one case, the effect of a lintel is analyzed. On the basis of the tests carried out, an analytical model was developed for the analysis of the OOP behavior. It was used to calibrate IP damage degradation models based on the experimental results to define limits for the applicability of well-known flexural and arching mechanism models for the evaluation of the OOP capacity of the infill walls and to evaluate the efficiency of vertical reinforcement. In this work, the experimental campaign is presented, and the results of both experimental tests and numerical analyses are discussed.

Copyright: © Francesca da Porto, Marco Donà, Nicolò Verlato, Giovanni Guidi
Lizenz:

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
    Datenseite
  • Reference-ID
    10535217
  • Veröffentlicht am:
    01.01.2021
  • Geändert am:
    02.06.2021
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine