Experimental Study on Bearing Capacity of Reinforced Steel Tubular Scaffold under Uniform Loads
Autor(en): |
Li Jia
Hongbo Liu Zhihua Chen Yang Liu Yapeng Wu |
---|---|
Medium: | Fachartikel |
Sprache(n): | Englisch |
Veröffentlicht in: | Advances in Civil Engineering, 2019, v. 2019 |
Seite(n): | 1-20 |
DOI: | 10.1155/2019/4324528 |
Abstrakt: |
Five groups of tests were designed to analyze the influence of node types (fastener connection and mortise-and-tenon joint) and reinforcement modes of top horizontal cross rods (weak truss and stiffening truss) on the bearing capacity of the steel tubular scaffold under vertical uniform loads. Loading phenomenon, bearing capacity, failure mode, displacement at key positions, and strain development characteristics during tests were analyzed. The following conclusions were drawn: (1) The fastener scaffold reinforced by a top truss showed the highest bearing capacity and high material utilization. (2) The fastener scaffold reinforced by a top weak truss increased the bearing capacity and caused coordinated deformation of the top horizontal force rods. (3) The node displacement of the mortise-and-tenon scaffold was smaller than that of the fastener joint, whereas its bearing capacity was higher. (4) Vertical diagonal bracing can slightly increase the bearing capacity of the mortise-and-tenon scaffold but can also constrain the deformation of the vertical rods and change the failure mode. |
Copyright: | © Li Jia et al. |
Lizenz: | Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden. |
11.64 MB
- Über diese
Datenseite - Reference-ID
10375754 - Veröffentlicht am:
02.10.2019 - Geändert am:
02.06.2021