Experimental Study of Frame-Supported Shear Wall Structure of High-Rise Buildings with Transfer Slab in Metro Depot

Taking the frame-supported shear wall structure of a 102.1 m high metro depot as the test object, the structure has obvious vertical irregularity, and a quasi-static test was carried out on the structural model with the scale of 1/5. The damage development and strain of the structure were observed by applying displacement loads under different seismic actions, and the experimental phenomena and measured data were analyzed. The results show that the safety performance of the structure meets the seismic requirements of the MCE (Maximum considered earthquake) condition. Under the action of load, a reasonable damage mechanism is formed in which the components above the transfer story crack first and those below the transfer story crack later, which is in line with the design concept of “the performance objective of the bottom frame structure is higher than that of the upper shear wall structure”. The transfer plate is mainly subjected to shear deformation, the possible shear failure of the transfer plate should be avoided by reasonable design. Due to the large height difference between the first floor and the second floor, the structure may be adversely affected, so it is necessary to make the yielding floor appear in the bottom strengthening part above the transfer story. Under the SLE (Service level earthquake) and DBE (Design based earthquake) conditions, the bottom frame of the structure is mainly subjected to elastic deformation. Under the MCE (Maximum considered earthquake) condition, the bottom frame of the structure causes a lot of damage, increases energy consumption and decreases stiffness, which further proves that “the performance goal of the bottom frame structure is higher than that of the upper shear wall structure”.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.