Experimental Investigation of Light Steel Framing Walls under Horizontal Loading

The mechanical behavior of light steel framing (LSF) walls under horizontal (shear) loadings is reported and assessed in this paper. In total, an experimental program with twelve LSF walls (six under monotonic and six under cyclic loading) was conducted, and the main parameters investigated were (i) the thickness and (ii) the material used as the cladding (OSB, a plasterboard, and a steel sheet), (iii) the spacing between fasteners (150 or 75 mm), and (iv) the influence of using steel bracing elements. It is concluded that doubling the number of fasteners and increasing the thickness of OSB by 80% lead to increases in ultimate loads, respectively, of 33 and 13%. The ductility index of the walls with steel sheets was 50 to 75% lower than those of the remaining walls. The wall with the steel strap x-bracing system presented (i) the lowest initial rigidity (a diaphragm effect could not be triggered with these elements) and (ii) the highest damage extent at the end of testing (a damage parameter of 0.85, due to damage of the steel strap-to-steel structure connection). It is confirmed that the results obtained with testing of the walls under a monotonic load can be good predictors of their behavior under cyclic loading as, for instance, the ultimate loads of walls under both loading cases present an average difference of 4%.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.