0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Experimental investigation of influence parameters on cartridge fired pin resistance

Autor(en): (Assistant professor Belgrade Republic of Serbia)
(Associate professor Belgrade Republic of Serbia)
(Associate professor Belgrade Republic of Serbia)
(Full professor Belgrade Republic of Serbia)
Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: ce/papers, , n. 3-4, v. 6
Seite(n): 1393-1398
DOI: 10.1002/cepa.2256
Abstrakt:

Cartridge fired pins, also known as powder actuated fasteners, have a wide application in different construction industry fields, mostly for joints of cold‐formed structural elements and profiled steel sheeting, or for installation of shear connectors in composite steel‐concrete structures. Installation of cartridge fired pins is mostly governed by high energy introduction from installation device and mechanical fastener to the steel base material, without initial predrilling of holes. Therefore, large plastic deformations of base material are developed through installation procedure, together with various anchorage mechanisms between fastener and base material. This paper presents experimental investigation of most important influence parameters on behaviour and resistance of cartridge fired pins, such as adjusted installation power level on installation device and steel base material strength. Experimental investigation involved X‐ENP‐21 HVB cartridge fired pins through double‐sided shear tests, tension tests with fasteners installed over X‐HVB shear connector with two different steel grades (S275 and S355) and two installation power levels (2 and 3.5), and tension tests with fasteners installed over two thicknesses of profiled steel sheeting (0.8 mm and 1.0 mm). Cartridge fired pin resistances together with corresponding failure mechanisms were experimentally quantified and presented in this paper.

Structurae kann Ihnen derzeit diese Veröffentlichung nicht im Volltext zur Verfügung stellen. Der Volltext ist beim Verlag erhältlich über die DOI: 10.1002/cepa.2256.
  • Über diese
    Datenseite
  • Reference-ID
    10767076
  • Veröffentlicht am:
    17.04.2024
  • Geändert am:
    17.04.2024
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine