Experimental and Numerical Simulation Investigations on the Bearing Capacity of Stepped Variable-Section DX Piles under Vertical Loading

As a new type of pile, the bearing characteristics of stepped variable-section DX piles (multi-joint extruded and expanded piles) are quite complicated; thus, their design concepts and pile-forming processes are still in the exploration stage, and their application in actual engineering is not particularly mature. The settlement law and load transfer law of the variable section DX pile have not been studied deeply, and the values of the parameters of engineering design are not clear, which are the problems to be solved for the variable section DX pile. To solve the above problems, the present study on the bearing characteristics of stepped variable-section DX piles under vertical loading is of great scientific significance and engineering practical value. In this study, the bearing capacity of a DX pile with two variable steps was first analyzed experimentally. Then, the bearing capacity of variable cross-section DX piles and equal cross-section piles were simulated under the same soil conditions. Later, the numerical simulation results were compared with the experimental results to verify the validity and accuracy of the numerical models established in ABAQUS software. Finally, the bearing capacity of stepped variable-section DX piles in different soil layers was analyzed numerically to compare the effect of different soils on the compressive bearing capacity of piles. The results indicated that the load-bearing plates had a greater influence on the bearing capacity of the stepped variable-section DX piles. At the optimum variable section ratio, which was close to 0.9, DX piles had a good bearing capacity. The relative errors of the numerical simulation ultimate loads were below 10%, which verified the accuracy of the developed numerical model. The simulated ultimate load of the equal-section pile was the smallest. The vertical compressive bearing capacity and the effect of controlling settlement under the same level of load of the variable section DX pile in sandy soil were both better than those in silt soil. There was little difference between the bearing capacities of the piles with a load-bearing plate. The bearing capacity of the pile with two load-bearing plates was the best, which can be used in practical engineering.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.