Experiment and Design Method of Cold-Formed Thin-Walled Steel Double-Lipped Equal-Leg Angle under Axial Compression

The cold-formed steel (CFS) double-lipped equal-leg angle is widely used in modular container houses and cold-formed steel buildings. To study the buckling behavior and bearing capacity design method of the cold-formed steel (CFS) double-lipped equal-leg angle under axial compression, 24 CFS double-lipped equal-leg angles with different sections and slenderness ratios the axial compression were conducted. The test results showed that the distortional buckling occurs for specimens with a small width-to-thickness ratio and small slenderness ratio. The buckling interactive with distortional and global flexural buckling was observed for the specimens with small width-to-thickness ratios and large slenderness ratios. The specimens with large width-to-thickness ratios and small slenderness ratios showed interactive buckling with local and distortion buckling. The specimens with large width-to-thickness ratios and large slenderness ratio developed interactive buckling with local, distortional, and global flexural buckling. The finite element model established by ABAQUS software was used to simulate and analyze the test. The buckling modes and the load-carrying capacities analyzed by the finite element model agreed with the test results, which showed that the developed finite element model was feasible to analyze the buckling and bearing capacity of the CFS double-lipped equal-leg angles. The experimental results were compared with those calculated by the direct strength method in the North American standard and the effective width method in the Chinese standard. The comparisons indicated that the calculated results are very conservative with maximum value 36% and 51% for direct strength method and effective width method, respectively. The coefficient of variation was 0.276 and 0.397, respectively. Finally, the modified direct strength method and the modified effective width method were proposed based on the experimental results. The comparison on the ultimate strength between test results and calculated results by using the modified method showed a good agreement. The modified method can be as a proposed desigh method for the ultimate strength of the CFS double-lipped equal-leg angles under axial compression.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.