Estimation of Influence Scope of Lateral Displacement of Soft Ground under Vacuum Pressure with PVD
Autor(en): |
Jingyun Liu
Hongtao Fu Jun Wang Yuanqiang Cai Xiuqing Hu |
---|---|
Medium: | Fachartikel |
Sprache(n): | Englisch |
Veröffentlicht in: | Advances in Civil Engineering, 2018, v. 2018 |
Seite(n): | 1-11 |
DOI: | 10.1155/2018/8248049 |
Abstrakt: |
The application of vacuum pressure to a treated area not only induces vertical settlement and inward lateral displacement but also causes the formation of tension cracks near the ground surface. In general, the strain method is applied to calculate the lateral displacement at the boundary of a treated area; however, the influence scope of lateral displacement has not yet been presented. Based on thein situdata of soft clayey soil foundation treated by vacuum consolidation, lateral displacement was estimated in the influence scope in this study. To calculate the influence scope of lateral displacement induced by vacuum pressure, the ratio of the lateral displacement within the influence scope to the ground surface settlement under the centre of the treated area is defined as the maximum value of the lateral displacement (ELD) within the influence scope. This paper proposes a direct relationship between ELD and the distance from the treated area boundary (Lx), considering the length of the prefabricated vertical drain. In addition, the FEA (finite-element analysis) is used to simulate the process of vacuum preloading to reinforce soft soil foundation. The influence scope simulated is almost close to the calculated valueLx. Accordingly, the safety distance between the boundary of the treated area and the surrounding building can be estimated when the soft soil foundation is consolidated by using a vacuum preloading method. |
Copyright: | © 2018 Jingyun Liu et al. |
Lizenz: | Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden. |
3.32 MB
- Über diese
Datenseite - Reference-ID
10176481 - Veröffentlicht am:
30.11.2018 - Geändert am:
02.06.2021