0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Effect of the Addition of Manganese Dioxide Nanoparticles on the Mechanical Properties of Concrete against Carbonation and Sulfate Attack

Autor(en): ORCID

ORCID

ORCID
ORCID
ORCID
Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Buildings, , n. 10, v. 14
Seite(n): 3094
DOI: 10.3390/buildings14103094
Abstrakt:

This study evaluates the impact of the addition of nanoparticles of anodic manganese dioxide (NAMD) on the mechanical properties and resistance to chemical attack of concrete. The research focused on nine concrete mixtures with water/cement ratios of 0.40, 0.45, and 0.50 and NAMD contents of 0, 5, and 10%. The properties of NAMD were analyzed, and fresh concrete properties such as temperature, unit weight, and consistency were measured. The compressive strength was determined at different ages (7, 14, 28, 56, and 90 days). The tensile and flexural strength were evaluated at 28 days, and the longitudinal change generated by the SO4Mg attack was monitored until 90 days. In addition, an accelerated carbonation test was performed on concrete samples with 28 days of curing exposed to an atmosphere of 6% CO2 for one week. The addition of NAMD did not significantly affect the temperature or unit weight of the fresh concrete, but it did influence the consistency. An increase in compressive, tensile, and flexural strength was observed, especially at early ages and for low w/c ratios. The addition of NAMD reduced the expansion of concrete exposed to magnesium sulfate, with 5% being the most effective dose, and reduced the carbonation rate of concrete by up to 40% in mixes with w/c ratios of 0.40 and 0.50. It was shown that the addition of 5% as an effective dose of NAMD improves the mechanical and durability properties of concrete, especially in mixtures with a low water/cement ratio, contributing to the improvement of the quality and strength of concrete.

Copyright: © 2024 by the authors; licensee MDPI, Basel, Switzerland.
Lizenz:

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
    Datenseite
  • Reference-ID
    10804934
  • Veröffentlicht am:
    10.11.2024
  • Geändert am:
    10.11.2024
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine