Effect of Filling Phosphogypsum on the Axial Compression Behavior of Cold-Formed Thin-Walled Steel Walls

To study the effect of filling phosphogypsum (PG) on the axial compression behavior of cold-formed thin-walled steel (CFS) walls, four full-scale test specimens were designed and fabricated, in consideration of the filling regions of PG as well as measures with or without wall sheathings. The fabricated specimens were tested under monotonic vertical loads, and the failure processes and failure modes of specimens were elaborated. Each specimen’s axial load-displacement curve, bearing capacity, strain curve, and energy dissipation capacity were investigated in detail. Furthermore, the internal force distributions of wall components and failure mechanisms were revealed. The test results indicated that the failure characteristics of specimens include the buckling of the steel tubes, cracking of wall sheathings, crushing of PG, and distorting of tracks. Compared with the cavity wall specimen, the axial bearing capacity of the specimen filled with PG in the studs only increased by 37.4%, and the bearing capacity of the specimen filled with PG in and between the studs increased by 115.7%. This indicates that filling PG can effectively improve the axial bearing capacity of CFS walls. The bearing capacity of the specimen without wall sheathings is lower than that of the specimen with wall sheathings, indicating that the wall sheathing has a beneficial effect on the bearing capacity of the specimen. In addition, the internal forces of components during the loading process were analyzed. It found that the steel tube and PG made a great contribution to the bearing capacity of the wall. Specifically, the steel tube played a leading role in the early loading stage, while the PG played a leading role in the later loading stage.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.