Effect of Drying and Wetting Cycles on the Surface Cracking and Hydro-Mechanical Behavior of Expansive Clays

Expansive clays present serious issues in a variety of engineering applications, including roadways, light buildings, and infrastructure, because of their notable volume changes with varying moisture content. Tough weather conditions can lead to drying and shrinking, which alters expansive clays’ hydro-mechanical properties and results in cracking. The hydro-mechanical behavior of Al-Ghatt expansive clay and the impact of wetting and drying cycles on the formation of surface cracks are addressed in this investigation. For four cycles of wetting and drying and three vertical stress levels, i.e., 50 kPa, 100 kPa, and 200 kPa, were investigated. The sizes and patterns of cracks were observed and classified. A simplified classification based on main track and secondary branch tracks is introduced. The vertical strain measure at each cycle, which showed swell and shrinkage, was plotted. The hydromechanical behavior of the clay, which corresponds to three levels of overburden stress as indicated by its swell potential and hydraulic conductivity was observed. It was found that at low overburden stresses of 50 kPa, the shrinkage is high and drops with increasing the number of cycles. Al-Ghatt clay’s tendency to crack is significantly reduced or eliminated by the 200 kPa overburden pressure. The results of this work can be used to calculate the depth of a foundation and the amount of partial soil replacement that is needed.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.