0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Ecological Upgrade of Normal-Strength Mortars by Using High Volume of GGBS

Autor(en):





Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Advances in Civil Engineering, , v. 2020
Seite(n): 1-13
DOI: 10.1155/2020/7101469
Abstrakt:

Normal-strength concrete is widely used in construction sites considering the cost, technology, and structural safety. The ecological upgrade of such materials is more meaningful for the sustainable development in a greener way. To this end, the feasibility of ecological upgrade of normal-strength mortars (NSM) by using high volume of ground granulated blast furnace slag (GGBS) (70%–90%) was evaluated in this paper. Comprehensive experiments were conducted to investigate the influences of experimental variables such as content of cement, curing temperature, and mass ratio of water to binder (w/b) on the fresh properties, compressive strength, hydration products, microstructure, and pore structure of NSM. Ecoefficiency evaluation was conducted based on the energy requirement for the whole production of cement and GGBS. Experimental results showed that ecological upgrade of NSM was viable and feasible. When substituting 70% to 90% cement by GGBS, the energy requirement of 1 t binder can be accordingly saved by 67% to 86%, and the performance energy can be reduced from 25.4 (kWh/t)/MPa to 6 to 8 (kWh/t)/MPa. With proper contents of GGBS (70% or 75%), the 28 d compressive strengths were acceptable with reductions less than 10%. Evaluated curing temperatures and decreasedw/bwere viable methods to promote the early-age compressive strength of NSM incorporating high volume of GGBS. For instance, raising the curing temperature to 40°C can help achieve higher early-age compressive strength than that of the control group. In addition, the pore sizes within ZII (<100 nm) of GGBS-incorporated NSM were refined by over 20 nm.

Copyright: © 2020 Peiyuan Chen et al.
Lizenz:

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
    Datenseite
  • Reference-ID
    10426562
  • Veröffentlicht am:
    13.07.2020
  • Geändert am:
    02.06.2021
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine