Dynamic Monitoring of Steel Beam Stress Based on PMN-PT Sensor

Steel beams are widely used load-bearing components in bridge construction. They are prone to internal stress concentration under low-frequency vibrations caused by natural disasters and adverse loads, leading to microcracks and fractures, thereby accelerating the instability of steel components. Therefore, dynamic stress monitoring of steel beams under low-frequency vibrations is crucial to ensure structural safety. This study proposed an external stress sensor based on PMN-PT material. The sensor has the advantages of high sensitivity, comprehensive frequency response, and fast response speed. To verify the accuracy and feasibility of the sensor in actual engineering, the LETRY universal testing machine and drop hammer impact system were used to carry out stress monitoring tests and finite element simulations on scaled I-shaped steel beams with PMN-PT sensors attached. The results show that: (1) The PMN-PT sensor has exceptionally high sensitivity, maintained at 1.716~1.726 V/MPa in the frequency range of 0~1000 Hz. The sensor performance is much higher than that of PVDF sensors with the same adhesive layer thickness. (2) Under low-frequency random vibration, the sensor’s time domain and frequency domain output voltages are always consistent with the waveform of the applied load, which can reflect the changes in the structural stress state in real time. (3) Under the impact of a drop hammer, the sensor signal response delay is only 0.001 s, and the sensitivity linear fitting degree is above 0.9. (4) The simulation and experimental results are highly consistent, confirming the superior performance of the PMN-PT sensor, which can be effectively used for stress monitoring of steel structures in low-frequency vibration environments.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.