Development of Filters with Minimal Hydraulic Resistance for Underground Water Intakes

The development of modern structures of water wells filtering equipment with enhanced performance characteristics is a vital task. The purpose of this work was to create filters for taking water from underground sources that have high performance, long service life, quickly and economically replace or repair in case of performance loss. The selection of the filter device must be made taking into account all the geological features of the aquifers, the performance characteristics of the filter devices and the size of the future structure. Filter equipment designs for water intake wells have been developed in this study. These filters have low hydraulic resistance, high performance and are easy to repair. This article presents the dependency of flow inside the receiving part of the well, the dependence of filter resistance at various forms of the cross section of the filter wire and the selected optimal section. The paper proposes a method for selecting the optimal cross-section of the filter wire used in the manufacture of a water well filter. The proposed structures of easy-to-remove well filters with increased productivity allow replacing the sealed well filter with a new one easily, reducing capital and operating costs, and increasing the inter-repair periods of their operation. Based on the presented method, examples are given for selecting the parameters of the filter wire cross-section. The above calculations showed that the use of the hydraulic resistance criterion at the design stage of underground water intakes can significantly reduce the cost of well construction. Studies have found that the minimum hydraulic resistance to ensure maximum filter performance is achieved when using filter wire teardrop and elliptical shapes.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.