Development of a New Nondestructive Method for the In-Situ Determination of Mortar Strength

The determination of the load bearing capacity of masonry in existing structures is not an easy task, even for experienced surveyors. For its assessment, it is necessary to know the compressive strength of the masonry units and mortar. Relatively good destructive and non-destructive methods were developed for the determination of the compressive strength of masonry units. However, mortar compressive strength determination is currently closer to a rough estimation rather than a deterministic approach. All of the currently used methods are either complicated, have a limited application, or are based on the surveyor’s experience only. Influence of the human factor on the results of testing is significant. The paper introduces the development of a new non-destructive method, which eliminates the influence of the human factor. The method is supposed to work as quickly and as easily as the Schmidt hammer used for concrete structure surveys. The new instrument was created where the compressive strength of mortar is assessed by hammering a steel bar into a joint with constant energy, while the depth of penetration is measured. The impact energy is provided by a steel spring with a prescribed stiffness, and the loading is provided by an automatic system similar to those used in air-soft guns.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.