Comparison Mechanical Properties of Two Types of Light Weight Aggregate Concrete

This paper presents the behavior of concrete properties by replacing the conventional coarse aggregate used in the concrete mixture by two types of lightweight aggregate; Expanded Perlite Aggregate (EPA) and Volcanic Pumice (VP). To fulfill this aim; three laboratory tests were applied; density, compressive strength, and abrasion resistance, that conducted to extrapolate the range of the changes in the properties of concrete with existence those types of aggregate in the mixture. Also, the volumetric proportion adopted as a strategy for replacing the coarse aggregate by EPA or VP in the concrete mixture. Then, the volumetric proportion ranged from 10% to 50% with the variation step was 10%. Therefore, ten concrete mixtures are prepared and divided into two groups; each group contains five concrete mixes to represent the volumetric replacement (10-50)% of conventional coarse aggregate by EPA or VP. On the other hand, one extra mixture designed by using conventional aggregate (coarse and fine aggregate) without any inclusion of EPA or VP to be considered as a reference mixture. The obtained laboratory results of this study proved that the density, compressive strength, and abrasion resistance readings of concrete decreased at any volumetric proportion replacement of coarse aggregate by EPA or VP. The decrease in density and compressive strength of concrete readings amounted the peak level at 50% replacing of coarse aggregate by EPA, which were 38.19% and 77.37%, respectively than the reference mixture. Additionally, the compressive strength is an important factor affecting the abrasion resistance of concrete mixture, and loss of abrasion decreased as compressive strength increased.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.