Calibration of the Live Load Factor for Highway Bridges with Different Requirements of Loading

Highway bridge load rating has been moving toward structural reliability since the issuance of AASHTO LRFR specifications; however, the recommended load factors were carried out by a few reliable truck data. The objective of this study is to calibrate the live load factor in AASHTO LRFR Rating Specification by using huge amount of WIM data collected in California for more than ten years between 2001 and 2013. Since traffic volumes, vehicular overloads, and traffic components are highly related to the load effect induced, a set of calibration equations is proposed here, in which the nominal standard load effect models are used and different requirements of loading are taken into account. By the analytical model of platoons of trucks and the extrapolation of the gathered WIM data over a short period of time to remote future over a longer time period, the expected maximum live load effects over the rating period of 5 years are also obtained. Then, the live load factor is calibrated as the product of the codified value multiplied by the ratio between the nominal standard load effect and the expected mean value. The results show that the products of the two ratios present rather constant, implying the proposed method and load configurations selected are effective. In the end, the live load factors of 1.0 and 0.7 along with load configurations are recommended for a simple span length less than 300 ft. The recommended calibration method and live load factors will eliminate the unnecessary overconservatism in rating specifications.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.