0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Anticipating the Compressive Strength of Hydrated Lime Cement Concrete Using Artificial Neural Network Model

Autor(en):



Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Civil Engineering Journal, , n. 12, v. 4
Seite(n): 3005
DOI: 10.28991/cej-03091216
Abstrakt:

In this research work, the levernberg Marquardt back propagation neural network was adequately trained to understand the relationship between the 28th day compressive strength values of hydrated lime cement concrete and their corresponding mix ratios with respect to curing age. Data used for the study were generated experimentally. A total of a hundred and fourteen (114) training data set were presented to the network. Eighty (80) of these were used for training the network, seventeen (17) were used for validation, and another seventeen (17) were used for testing the network's performance. Six (6) data set were left out and later used to test the adequacy of the network predictions. The outcome of results of the created network was close to that of the experimental efforts. The lowest and highest correlation coefficient recorded for all data samples used for developing the network were 0.901 and 0.984 for the test and training samples respectively. These values were close to 1. T-value obtained from the adequacy test carried out between experimental and model generated data was 1.437. This is less than 2.064, which is the T values from statistical table at 95% confidence limit. These results proved that the network made reliable predictions. Maximum compressive strength achieved from experimental works was 30.83N/mm² at a water-cement ratio of 0.562 and a percentage replacement of ordinary portland cement with hydrated lime of 18.75%. Generally, for hydrated lime to be used in making structural concrete, ordinary portland cement percentage replacement with hydrated lime must not be up to 30%. With the use of the developed artificial neural network model, mix design procedure for hydrated lime cement concrete can be carried out with lesser time and energy requirements, when compared to the traditional method. This is because, the need to prepare trial mixes that will be cured, and tested in the laboratory, will no longer be required.

Copyright: © 2018 Chioma Temitope Gloria Awodiji, Davis Ogbonnaya Onwuka, Chinenye Okere, Owus Ibearugbulem
Lizenz:

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
    Datenseite
  • Reference-ID
    10340848
  • Veröffentlicht am:
    14.08.2019
  • Geändert am:
    02.06.2021
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine