0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Analysis of Different Stripe Connectors for a Gabion Wall based on Woven Waste Tire Stripes

Autor(en):




Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Civil Engineering Dimension / Dimensi Teknik Sipil, , n. 2, v. 21
Seite(n): 66-69
DOI: 10.9744/ced.21.2.66-69
Abstrakt:

In this research, woven waste tire stripes are proposed as an alternative material to wire mesh to make a gabion wall. The performance of the waste tire stripe-based gabion wall is highly dependent on the strength of its stripe, where the stripe connector plays an important role. This research aims to inspect the behavior of different stripe connectors for the gabion wall. To achieve this, a physical model was built and employed to test the strength of the gabion wall. Various stripe connectors are used; adhesive rubber glue, one inch nail, and two mm wire. The strength capacity of the models was determined from the maximum stress before failure. The strength capacities of the models are 83.197, 59.426 and 62.397 kPa for the wire, nail, and glue connector, respectively. Hence, it can be inferred that the wire connector is the strongest of the three connectors.

Structurae kann Ihnen derzeit diese Veröffentlichung nicht im Volltext zur Verfügung stellen. Der Volltext ist beim Verlag erhältlich über die DOI: 10.9744/ced.21.2.66-69.
  • Über diese
    Datenseite
  • Reference-ID
    10376804
  • Veröffentlicht am:
    19.10.2019
  • Geändert am:
    19.10.2019
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine