- Detection and characterization of matrix cracking in fiber‐metal laminates using Lamb wave propagation. In: Structural Control and Health Monitoring, v. 29, n. 10 (13 September 2022). (2022):
- A novel rate-dependent cohesive zone model for simulation of mode I dynamic delamination in laminated composites. In: Composite Structures, v. 281 (Februar 2022). (2022):
- Wing instability of a full composite aircraft. In: Composite Structures, v. 54, n. 2-3 (November 2001). (2001):
- Analysis and optimization of a composite leaf spring. In: Composite Structures, v. 60, n. 3 (Mai 2003). (2003):
- Shear buckling of a composite drive shaft under torsion. In: Composite Structures, v. 64, n. 1 (April 2004). (2004):
- Parametric study of automotive composite bumper beams subjected to low-velocity impacts. In: Composite Structures, v. 68, n. 4 (Mai 2005). (2005):
- Simulation of fatigue failure in a full composite wind turbine blade. In: Composite Structures, v. 74, n. 3 (August 2006). (2006):
- Experimental evaluation of dynamic behavior of metallic plates reinforced by polymer matrix composites. In: Composite Structures, v. 75, n. 1-4 (September 2006). (2006):
- On the reinforcement of concrete sleepers by composite materials. In: Composite Structures, v. 76, n. 4 (Dezember 2006). (2006):
- The effect of time-dependent slightly weakened interface on the viscoelastic properties of CNT/polymer nanocomposites. In: Composite Structures, v. 146 (Juni 2016). (2016):
- A strain-rate dependent micromechanical constitutive model for glass/epoxy composites. In: Composite Structures, v. 121 (März 2015). (2015):
- Strain-rate dependent micromechanical method to investigate the strength properties of glass/epoxy composites. In: Composite Structures, v. 111 (Mai 2014). (2014):
- A new analytical model for calculation of stiffness of three-dimensional four-directional braided composites. In: Composite Structures, v. 94, n. 3 (Februar 2012). (2012):
- Investigating the transverse behavior of Glass–Epoxy composites under intermediate strain rates. In: Composite Structures, v. 93, n. 2 (Januar 2011). (2011):
- An analytical method for calculating stiffness of two-dimensional tri-axial braided composites. In: Composite Structures, v. 92, n. 12 (November 2010). (2010):
- Investigation of nanotube length effect on the reinforcement efficiency in carbon nanotube based composites. In: Composite Structures, v. 92, n. 10 (September 2010). (2010):
- On the tensile behavior of an embedded carbon nanotube in polymer matrix with non-bonded interphase region. In: Composite Structures, v. 92, n. 3 (Februar 2010). (2010):
- Investigation of strain rate effects on in-plane shear properties of glass/epoxy composites. In: Composite Structures, v. 91, n. 1 (November 2009). (2009):
- Compressive response of glass–fiber reinforced polymeric composites to increasing compressive strain rates. In: Composite Structures, v. 89, n. 4 (August 2009). (2009):
- Tension behavior of unidirectional glass/epoxy composites under different strain rates. In: Composite Structures, v. 88, n. 4 (Mai 2009). (2009):
- Residual stiffness in cross-ply laminates subjected to cyclic loading. In: Composite Structures, v. 85, n. 3 (Oktober 2008). (2008):