Design of Structural Steel Components According to Manufacturing Possibilities of the Robot-Guided DED-Arc Process

Additive manufacturing with the DED-arc process offers limited freedom in terms of the geometric shape of work pieces. The process and fabrication systems restrict the part geometry producible, which must be taken into account during design already. For this reason, a design process was investigated in which geometry generation is based on a self-organizing system. The aim of using a self-organizing system is the possibility to directly control the geometry-defining points. Next to load cases, the design method considers geometric boundary conditions from the production process when generating the geometry. In order to identify these geometrical constraints from production experimentally, a concept of Case Study Demonstrators was applied. This was used to investigate how path planning and production can be carried out for specific geometrical features and to identify restraints of the process and the manufacturing system, e.g., smallest producible wall thickness and overhangs. Subsequently, the obtained restraints were considered as boundary conditions for the design process and were included in the modification of an example geometry. By applying the presented design method, it was possible to maintain a minimum wall thickness throughout the structure while generating a topologically optimized geometry. In contrast to compliance with the minimum wall thickness, no satisfactory behavioral rule could be found for limiting the overhang.

This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met.