High-Temperature Behavior of Carbon Reinforced Concrete

Carbon reinforced concrete is perceived by industry as a promising alternative to the currently established construction products. Previous building authority approvals and approvals for this construction method largely exclude questions of preventive fire protection with regard to load-bearing behavior under fire because there are hardly any reliable research results available in this field. This article shows the results of experimental investigations including thermogravimetric analyses of carbon reinforcement and tensile tests on the composite material carbon reinforced concrete. The thermogravimetric analyses show the loss of mass of the carbon reinforcement under a temperature load. A decomposition of the coating system of the carbon fibers and, with increasing temperature load, also of the carbon was observed. By varying various boundary conditions, such as the heating rate and the oxygen content present, their influences can be assessed. Stationary and non-stationary tensile tests on strip-shaped carbon reinforced concrete specimens were used to determine the load-bearing and deformation behavior in the high-temperature range up to 700 °C. The investigations were carried out under constant heating rates of 2 K/min and 10 K/min. This made it possible to obtain stress-strain curves and information on the various temperature-dependent deformation components from mechanical strains and load-independent strains. The time- and temperature-dependent decomposition of the carbon resulted in a reduction in the tensile load-bearing capacity of the reinforcement in the high-temperature range. This effect can be taken into account by considering the cross-sectional loss of the carbon reinforcement in a hot design.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.