0
  • DE
  • EN
  • FR
  • International Database and Gallery of Structures

Advertisement

General Information

Beginning of works: January 2016
Completion: November 2016
Status: in use

Project Type

Awards and Distinctions

2018 Honorable Mention  

Location

Location: , , ,
Crosses: A 8 Motorway (Germany)
Coordinates: 48° 44' 16.67" N    9° 2' 18.07" E
Show coordinates on a map

Technical Information

Dimensions

total length 82.78 m
deck width 6.00 m
bridge surface 451.02 m²
total width 6.75 m
abutments number 2
arch rise 4.93 m
arch span 59.75 m
deck total length 75.17 m
deck slab thickness 0.40 m
roadway / carriageway width 5.00 m

Quantities

substructure concrete volume 321 m³
prestressing steel 54 t
superstructure structural steel 160 t
concrete volume 246 m³
reinforcing steel 56 t

Design Loads

design code(s) DIN EN 1991-2 / NA

Cost

cost of construction Euro 3 670 000

Materials

deck composite steel-reinforced concrete
arch steel
piers on arch steel

Notes

For the widening of the A8 Federal Motorway by an additional lane between the Stuttgart interchange and the junction Leonberg/Ost a replacement bridge was necessary. Because of its restricted structural clearance, the existing arch bridge “Rotes Steigle” was replaced by a distinctive new structure, which provides a crossing for a forest road over the highway. The load bearing structure of the integral composite bridge comprises a lower arched steel box girder with varying cross-section dimensions, steel struts that are angled outwards, and a reinforced concrete deck slab. The slender construction was designed as a two-hinged arch that rests on stainless steel rocker bearings at the arch-support. The superstructure is supported on the arch by slender, inclined steel braces. The deck is monolithically connected to each abutment via a thin vertical steel plate acting as an elastic spring (height of approx. 1.10 m, thickness of merely 2 cm). The individual steel elements were pre-assembled into two large segments of 120 t each, which could rapidly be installed. This way, the highway had to be closed for only two nights. The concrete work on the deck could be carried out without the need for further interuptions to highway traffic. Due to the incremental production of the steel structure and the bridge deck, the fabrication and the execution of the construction work called for extensive deformation analyses and camber calculations. Specific measures that had to be taken during the construction include the pre-stressing of the arch, and the subsequent casting of the abutment base and the lamella-spring support plates. Another special feature is the use of the latest generation of a new expansion joint system, which was applied at the transition joint between the superstructure and the abutment. Now, a slender steel arch structure presents a modern contrast to the previous bridge.

Relevant Web Sites

Relevant Publications

  • About this
    data sheet
  • Structure-ID
    20074773
  • Published on:
    16/02/2018
  • Last updated on:
    18/07/2021
Structurae cooperates with
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine